The MPC 7075 control panel is an analog electronic control panel, which, depending on the independent transformer, can work at 12 or 24V, for swing gate automations, for 1 or 2 motors (165x120x50Hmm).

MPC sought to maintain the application of low voltage accessories in a connection strip apart from the high voltage strip for power supply and connection of the automations and protection for the two differently.

The 7075 is an electronic control unit with reduced speed, this function allows not only to smooth the movement of the gate, but also to extend the longevity of the applied automatisms.

It has a wide range of operating logic from opening and closing when necessary to the automatic condominium. It also has a dip rule, where you can activate other equipment, such as an electric lock and a fixed or flashing firefly. It includes a 12V battery connection (maximum 7Ap), which in the event of a power failure, the automation makes its normal movement, only slower.

7075, it has a built-in receiver for the total opening of the gate (Start) and the opening of a leaf (when we have 2 leaves at the gate) just for pedestrian crossing (Pedestrian Start), etc.

The MPC 7075 control panel provides for the installation of all security systems required by the Standards in force. As is common knowledge in stop automations, the Standard provides for the application of indoor and outdoor sensors and with the installation of a pneumatic coast.